Double-Flanged Support – The support consists of four distinct corners folded inward forming a box shape, opened at the bottom. The ends are opened to fit closely over and around the top of the front and rear rack beams. Holes are punched on the flanged section at the ends that wrap around the beam so that tek screws may be applied to prevent movement of the support on the beam.

Top-Hat Style Support – This support also contains four distinct corners however, the bottom edge is folded outward not inward, leaving the bottom fully open. The support is cut to be flush at the end allowing it to butt up against the inside step portion of the rack beam, while the bottom flared section rests on the inside step of the rack’s step beam. Holes are punched on the bottom edge that is folded outward for the addition of tek screws to prevent movement of the support on the beam. Once attached, the top of the support is flush with the front and rear beams.

The Benefits:
•Reduces the potential for bowed rack beams when properly attached

•Helps to stabilize the entire rack system

•Helps forklift operators to load pallets on deep and hard-to-see rack sections by providing a place to “catch” a misaligned pallet

•Provides an added layer of protection for pallets by reducing the potential for dropped loads

•Opened style of the support prevents water, foreign material, and debris from becoming trapped

•Use of 14 & 16 GA galvanized-structural sheet steel reduces the potential for rust while providing
the strength needed to create a stable platform with a yield strength that exceeds many of the competitors’ offerings

•Durable galvanized finish will provide years of protection

•Note: Pallet supports do not contribute to the load capacities sited by the rack manufacturers. Pallet supports are intended to add support to the pallets, while load capacities are determined by the configuration of the rack and type of beams used. Pallet supports help to facilitate the overall effectiveness of the rack system whereby improving stability, workability, and safety of the system.

Hole each end for tek screws
Beam may be either
structural or roll-formed
Double Flange Pallet Support

Holes are punched on both ends which overlap the beams for tek screws. (For illustration purposes only)
Double Flange Pallet Support

Holes are punched on both ends which overlap the beams for tek screws. Bottom section of support is opened and formed for increased strength and rigidity. (For illustration purposes only)

Hole each corner for
Support rests on step of roll-formed beam

tek screwsTop Hat Pallet Support
(Top View)
Holes punched on flange for tek screws with bottom opened and
formed for increased strength and rigidity.
(For illustration purposes only)
Top Hat Pallet Support
(Side View)
Holes punched on flange for tek screws with bottom opened and
formed for increased strength and rigidity.
(For illustration purposes only)